GREENS is available across NZ and Australia. Please refer to our stockist finder.
Not only do we supply beautiful NZ designed tapware we also offer amazing shower options which
include exclusive KIWI ingenuity. While you’re there, why not make over
the entire bathroom and add in some matching accessories.
Well, that depends on how long you stay in there once you feel the difference, but no, our
technology is about how we disburse the water through our exclusive designs, however its not our
fault if you don’t want to leave your shower.
Well, that depends on what you want from your shower. If you want a luxurious relaxing soft shower then our ranges with RainBoost® technology will set you up for a great nights sleep, Or if you are looking for an invigorating full coverage spray then our AirFlo™ technology may be the one for you… Not sure? then perhaps its a combination with our multi-function handsets.
Okay let’s get technical, our RainBoost® technology shower helps promote a good night’s sleep, by creating a full coverage soft experience which will make a world of difference in your daily showering experience. RainBoost® shower technology has been specifically designed and developed for varying water pressure conditions.
Engineered to maximise shower flow and coverage out of low pressure water systems down to 10kPa, as well as performing on high water pressure systems. For unrivalled performance on low pressure or gravity fed systems ensure you combine it with a Greens shower mixer with a low pressure cartridge suitable for all pressures.
Min 10kPa | Unequal
Min 20kPa | Equal
The AirFlo® shower range uses advanced technology to push air into the water stream to filling the water droplets with tiny bubbles of air to create a wonderful, invigorating spray. AirFlo® features an adjustable multifunction spray handset with three spray patterns - normal, massage, and combined. It comes in both round (Glint) and square (Swept) designs to match your décor and, better yet, is still water efficient with a 3 Star WELS rating.
Yes! But some will be easier than others.
We have a wide range of options that have varying degrees of installation – please check out our showers range HERE
Yes, Greens has some beautiful ranges depending on your style and room you want to upgrade your current tap set from. Kitchen mixers such as the Galiano add a sophisticated style to any kitchen or laundry, or our beautiful Tesora range will add glamour to any bathroom, check out our ranges HERE
Please check and ensure that the handle of the tap is in the ON position to allow free water flow. If the mixer is on and there is still no response to the touch sense follow the following video instruction.
If you need to override the touch sense and put your mixer into a manual operation mode please] following the instruction on the video below.
Please check with the hot water manufacturer prior to installing your mixers or showers. Please make sure the minimum delivery is sufficient to deliver hot water.
Yes. Our warranty is limited to 500kpa. Anything over that will require a PLV (Pressure Limiting Valve) installed to maintain the warranty.
Products should be cleaned with a soft cloth and water. Never use harsh detergents, solvents or acidic cleaners, citrus based cleaners, lime scale removers, household vinegar, and cleaning agents containing acetic acid on any Products as these will scratch and damage the surface.
Additionally, use of wax based furniture cream should be avoided as these can result in a build-up of deposits, which could detract from the appearance.
Any damage caused by the use of unsuitable cleaning products will not be covered by warranty.
Yes. It is recommended that the plumber follows the installation instructions enclosed with the product, this sheet details essential information including the maximum water pressure.
No. Replacing a cartridge is reasonably easy, here are the steps.
1. For wall mixers, turn off water at the mains. Basin / Sink you may have mini taps which you can switch off, if not available switch off at mains.
2. Locate and remove grub screw cover. This could be under the front or rear of handle.
3. With an allen key, loosen Grub screw that holds on the handle.
4. Remove handle, and Remove cartridge dome by pulling away or twist off.
5. Undo Cartridge Retaining nut with a shifter or spanner.
6. Remove cartridge, this can be tight so pliers maybe required.
7. Replace Cartridge and ensure the locating pins are pushed into the body of the mixer.
8. Re-assemble in reverse order.
9. Turn on water at the mains and check for leaks.
No. Blockages are not considered a product fault.
The following information describes the necessary steps required for consumers to create an account and register products on the Greens, Product Registration Portal.
1. How To Create An Account To Register Products.
1.1. Visit the Greens, product registration portal website: www.greenstapware.com/my-account/
1.2. Create an account using the following information:
- First & Last Name
- Company/Organisation Name (optional)
- Email Address
- Password
- Country
- Residential Address
- Mobile Number
1.3. Setup 2FA (Two-Factor Authentication) using your email and/or phone number.
1.4. Click on “Create Account” to complete the account creation process.
2. How To Register Products.
2.1. Login to your account and click on “Add New Registration” to begin the registration of your products.
The following Information will be required in order to successfully register a product.
- Product Name - Select your product from the drop down box
- Purchase Date - Refer to your invoice for the purchase date
- Purchased From - Vendor/store name
2.2. Click on “Choose File” and upload a copy of the product invoice and installation invoice.
Note - The product invoice must show the product name, purchase date and where the product was purchased from.
The Installation invoice must show the company's name and the date of installation.
2.3. Agree to the warranty terms and conditions by ticking the box.
2.4. Click on "Register New Product" to complete the registration.
